assistantloading.blogg.se - Grand prix key fob programming instructions

If there is another way GM isn't telling me about it. Operate the transmitter functions in order to verify correct system operation. Repeat the previous step in order to program up to 4 transmitters. After a delay of 5-10 seconds, the scan tool will indicate that the transmitter is programmed. Press and hold the LOCK button and the UNLOCK button simultaneously on one transmitter.

Important: The scan tool must stay connected until all of the transmitters are programmed. Press the START soft key on the scan tool. Use the scan tool in order to access programming: Vehicle Control System/Computer Integrating System/Module Setup/BCM/Program Key Fobs.

This prevents the programming of the transmitters to the incorrect vehicle. Do not operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry program mode.

If the system is placed in program mode it will erase all previously programmed transmitters upon the receipt of the programming signal from the first transmitter. Important: All transmitters which are to be recognized by the remote control door lock receiver (RCDLR) must be programmed in a single programming sequence. Remote Control Door Lock Transmitter Programming

Do not remove ground wire between programming of keyless remotes.

Repeat step four to program any additional keyless remotes including the pre existing keyless remotes.

System will respond by locking and unlocking doors one time to indicate successful programming.

Press any button on the keyless remote.

System will now lock and unlock doors automatically to indicate programming mode has been activated.Leave connector wire connected to ground throughout the procedure. Ground the terminal in the connector to a nearby bolt or trunk latch. How to Program a 2001 Pontiac Grand Prix Keyless Entry Remote Fob Step by Step How to Programming Instructions: IMPORTANT: Before entering programming mode, have in possession all of the remotes you will be using on the vehicle. The programming connector wire should have one terminal in the plastic connector on the end of a black/white wire.You may have to pull back the right side trunk trim on the trunk wall to locate the single black/white wire. Locate the programming connector wire located in the right-hand trunk area.Existing working remotes will have to be reprogrammed also. Instructions for Models: 1991-1996 Buick Regal, 1994-2001 Chevrolet Lumina, 1995-1996 Chevrolet Monte Carlo, 1994-1997 Oldsmobile Cutlass Supreme, 1994-1996 Pontiac Grand Prix NOTE: Existing keyless remotes will be erased with this procedure. 1991 - 2001 Buick, Chevrolet, Oldsmobile, Pontiac Vehicles Remote Programming Instructions (Select Models)